top of page

Our new Twisty Stamper!

Do you wish to tailor your stamping images in a different size? With our new stamper you can now stamp in regular size or go smaller or bigger of any stamping plate image!


Please see our demo here.


Transparent cap & scraper is included.


Stamping head size: approx 35mm


THIS STAMPER NEEDS MINIMAL EFFORT! Use straight out the pack and just gently roll over the image :)

Please check out the CARE INSTRUCTIONS & HOW TO! 



NSQ UK - "Twisty" Clear Stamper & Scraper

  • Stamping Head Cleaning

    Clean your stamper head using any sticky tape (lint roller, masking tape, Scotch tape) between uses. Do not use pure acetone or nail polish remover to clean stamper head. When you first receive your stamper it should work ideally right from opening the package but in the event it has trouble picking up stamping images you may try washing stamper head in warm soapy water and let it air dry.

    Stamper Body Cleaning

    Never use pure acetone on the stamper body as the stamper body can become cloudy when cleaned with acetone. We recommend a gentle non-acetone remover Nail Polish Remover or cleanser when cleaning the stamper body.

    How To Stamp

    If you still have problems picking up stamping image, please check our tips & tricks about stamping:

    • Remove your new stamping plate from its packaging and remove the plastic protective film from over the metal. When you first receive your plate and after every use wipe clean your plate with acetone or non-acetone nail polish remover without oils. Сlean your stamper with tape by using the sticky side to remove dry polish.
    • Quickly apply a thick layer of nail polish in a few strokes over the design you wish to stamp. Special stamping polishes are recommended but opaque nail polishes that do not dry very fast also work well. Try another polish if you are not getting results you want.
    • Hold a plastic card firmly at a 45 degree angle and lightly scrape across the plate to remove excess polish. Try to only scrape once, do not push card to plate too hard and work as quickly as possible to avoid drying.
    • Immediately after scraping, quickly transfer the design to your stamper by lightly rolling once across the design from one side to the other or pushing once straight into the design.
    • If your image does not transfer you may need to work faster, scrape differently (less pressure or new angle), prime your stamper (with acetone or gentle nail file/buffer) or try another opaque nail polish that doesn’t dry very fast.
    • Quickly transfer the image from the stamper onto a nail with an oil free and completely dry base color. With a squishier stamper push the stamper straight to the nail, with other stamper heads it might work better to roll it once from side to side to transfer image. Remove excess nail polish from your skin and cuticles by using a flat brush or cotton swab dipped in acetone or nail polish remover, you could use tape to lift excess polish from your skin as well.
    • When design is completely dry on your nail, apply a layer of fresh top coat with as few strokes as possible. Place a big drop at the cuticle and hold brush parallel to the nail while applying trying not to touch the nail with the bristles, this helps prevents smearing.
bottom of page